Control Column's in Ctrl-Yf-level

left Control Column's in Ctrl-Yf-level

Manipulate intarsia-park-positon

for using more than one yarn feeder in a intarsia-level

MMMMMM<<aMMMMM ] Zeile 3

2bc>b MMMMMc MMMMMM ] Zeile 2

2bc>aa MMMMab>>MMMMMM ] Zeile 1

----------------------

000000......223333..445

123456......890123..890

|||||| |||> YC [a] comes from his right park position

|||||| ||> [>] Change the direction of carriage: now from left

|||||| |> [<] Change the direction of carriage: now from right

|||||| > YC [b] and [c] are coming from their left park-position

|||||> By user forced yarn feeder for this line

||||> Actual yarn feeder used for this line by MODEX

|||> Shows the actual carriage-direction of yarn feeder

||> [b] Yarn feeder in swinging position:

|| Surrounding needles of yarn feeder are protected to transfer

|| (Area of -1..+1);

|> Yarnfeeder-postion-corretion-techno (only for full-intarsia)

| (If value of correction-position equal or bigger then value of

| Intarsia-parameter)

| [.],[a]: correction with function of STRUCTUR-level

| [b] : correction with cut

| [c] : correction with 1 by 1 stitch techno

| (In the intarsia-function-set, the system must find

| Alternative INEL,-INAL,-INER,-INAR

| With parameter "1X1,")

| [d] : correction only with the function of INEL,INAL,INER,INAR

> More then one YC with the same yarn-feeder-colour are used in this intarsia-Level :[2],[3],[4],[5],[6];

right Control Column's in Ctrl-Yf-level

Building groups of YC in one system

• Starting in the first column!
• The intarsia-parameter must be set “Manual Yarn-feeder-Sequence in Ctrl-Yf-Level”
• Must be defined in every phase
• After every group follows a [.];
• All used yarn feeder must be found
• A group can be also one yarn feeder
• The influence of sequence is important

Example:

[ade.bf.i.cg.................];

1.Group: Intarsia-YC [a]+[d]+[e] working in one system

2.Group: Intarsia-YC [b]+[f] working in one system

3.Group: Intarsia-YC [c]+[g] working in one system

4.Group: Intarsia-YC [i] only one yarn feeder in one system

[ade./bf.cg.bf.............];

---

To define kicking sequences while using Normal-Yf use [/] or [\] to mark each kicking sequence

Example for a 6 Colour Intarsia with Normal Yarn feeders:

While using manual kicking sequences in combination with structure knitting in Structure-Level the column 13 (YC.Movement of transfer-elements) should be coloured with [c];